Model 1900 chamber length????
-
- Posts: 1127
- Joined: Sat Mar 22, 2003 11:06 pm
- Location: Washington and Alaska
Chamber Lengths
Chamber lengths and the shell length the original manufacturer intended can be a tricky and convoluted subject. Several of the old double gun manufacturers held their chambers about 1/8 of an inch shorter then the shell for which they were intended. I know A.H. Fox Gun Co. and Parker Bros. did this. So, a 12-gauge gun with a 2 5/8 inch chamber was intended for 2 3/4 inch shells. In the recently published book "The Parker Story" the Remington vintage specification sheets on pages 164 to 169 call for a chamber 1/8-inch shorter than the shell for which it is intended. Also in the 1930's there were a couple of articles in "The American Rifleman" (July 1936 and March 1938) on the virtue of short chambers. A recent issue of The Double Gun Journal carried an article on tests showing no significant increase in pressure from shooting shells in slightly short chambers. IMHO I don't much sweat that 1/8-inch in 12-gauge guns. On the other hand when one gets a 20-gauge chambered at 2 3/8-inch likely intended for 2 1/2-inch shells I do worry about folks firing 2 3/4-inch shells in such guns.
You need to check out Charles G. Semmer's book "Remington Double Shotguns." It is available from the author 7885 Cyd Drive, Denver, CO 80221, for $60 plus $5 shipping and handling. It is invaluable if you are going to shoot, invest, collect or play in the Remington double gun field. Remington supplied a number of different pattern Damascus barrels on these old doubles. A picture of their salesman’s sample of the various styles of Damascus available is shown on page 275 of Semmer's book.
Remington Arms Co. stamped the actual pellet counts of their test patterns on the rear barrel lug of their Model 1889 hammer doubles and their Model 1894 and 1900 hammerless doubles. If the number is three digits, that is the count, if the number is two digits a leading 3 is implied. From surviving hang-tags we know the standard load they used to target 12-gauge guns was 1 1/4 ounces of #8 going 511 pellets to the load. My 12-gauge KE-Grade Model 1900 is stamped 33 on the left and 24 on the right. That would be 333/511 = 65% left and 324/511 = 64% right, or about improved modified in both barrels. The chokes measure .027" in both barrels of that gun.
You need to check out Charles G. Semmer's book "Remington Double Shotguns." It is available from the author 7885 Cyd Drive, Denver, CO 80221, for $60 plus $5 shipping and handling. It is invaluable if you are going to shoot, invest, collect or play in the Remington double gun field. Remington supplied a number of different pattern Damascus barrels on these old doubles. A picture of their salesman’s sample of the various styles of Damascus available is shown on page 275 of Semmer's book.
Remington Arms Co. stamped the actual pellet counts of their test patterns on the rear barrel lug of their Model 1889 hammer doubles and their Model 1894 and 1900 hammerless doubles. If the number is three digits, that is the count, if the number is two digits a leading 3 is implied. From surviving hang-tags we know the standard load they used to target 12-gauge guns was 1 1/4 ounces of #8 going 511 pellets to the load. My 12-gauge KE-Grade Model 1900 is stamped 33 on the left and 24 on the right. That would be 333/511 = 65% left and 324/511 = 64% right, or about improved modified in both barrels. The chokes measure .027" in both barrels of that gun.