1964 model 1100 replacement sights

[Supercazzola]

I recently obtained my Dad's 1100 Remington. On the barrel, rear sights, it appears a piece is broken. Anyone know where I could obtain another one? I am completely a noob when it comes to this firearm, so forgive me if this is in wrong location.
Thanks


I believe it's called a rear sight aperture

[Supercazzola]

Found some on eBay. Apparently the same sights were used on early model 700, just in case anyone is looking (or participates in this forum)

[Virginian]

Glad you found what you needed. I didn't even realize they offered slug barrels back then, and I have a '63, bought new.
I did a little checking, and it appears the deer barrel wasn't available before 1966, so the barrel may not be original to the gun.

[Supercazzola]

I wasn't aware of it. Mine isn't rifled, and has a bit of blueing wear on the bottom. Its got to be an old one. i will check to see if there's a serial # on it.

I imagine newer barrels for newer 1100 would work too, but this belonged to my father, so I wanted the sights.

[Virginian]

1100s have never had the serial numbers on the barrels, but any 2-3/4" barrel from 1963 to the present will fit just fine on a 2-3/4" receiver. They make a whole lot of newer shotguns, but I have yet to find one I like better.