Joint Check for Model 1900 SxS

[TroutBum]

I have a Model 1900 SxS 12 ga (made in 1901). The small part on top of the Joint Check that lifts the Extractor has broken off so I extract spent shells by hand. Does anyone know of a replacement source?

[Jay Huber]

I probably have the part you need but am not quite sure what you are referring too. Are you talking about the part that screws into the front of the receiver that pushes the extractor arm in the barrel when you open the barrels away from the receiver? If you have a fax machine I could send you a parts list and you could identify the part. Jay Huber

[TroutBum]

Hi Jay,

Yes.....that is the correct part. I found an online diagram and it referenced the part as the Joint Check. Can you advise part cost?

[Jay Huber]

Yes I Have one. I assume you have the screw in the old one. I want $25 for it. Send me your address and check. Jay Huber 1430 NE 57th Court Ft. Lauderdale FL. 33334-6118 and your address.

[TroutBum]

I'll take it. I'll get a check in the mail along with a copy of the email as reference.