Stripper Clips

MadScotsMan · Post by **MadScotsMan** » Fri Jun 17, 2005 8:04 pm

Did the Model 8 in .35 Remington originally use stripper clips? The receiver appears to be notched for them. If they did, does anyone know of a source for the clips?
Thanks!

Huber Jay · Post by **Huber Jay** » Wed Jun 22, 2005 1:48 pm

I believe the gun could use stripper clips. Look in PARTS & SERVICE this site. JAY HUBER RSA

333_okh · Post by **333_okh** » Mon Jun 27, 2005 11:40 pm

They were supplied with each rifle. Early models were of a corigated brass, but other later were stamped steel. When shopping for these make sure you get the more common 35 Rem / 300 Sav model, because the ones made for the 25/30/32 Rem are too small for your gun.

MadScotsMan · Post by **MadScotsMan** » Thu Jun 30, 2005 3:51 am

Thanks for the info!

333_okh · Post by **333_okh** » Sun Jul 10, 2005 2:28 pm

Make sure and check eBay. Recently a few of them have gone by in auction. When searching look up Remington Model 8 and you will get just a few hits. If they are there you will see them. Sometimes you can find them by searching for 'stripper clip' but you will need to wade through a lot of auctions and you need to know what your looking for. I was also recently warned that Rem Model 30 rifles came with similar but not exact clips.

333

333_okh · Post by **333_okh** » Thu Jul 14, 2005 5:56 pm

http://cgi.ebay.com/ws/eBayISAPI.dll?Vi ... :B:SS:US:1

Remington Society

A Organization Dedicated to the study of Remington Firearms

Stripper Clips

Stripper Clips

Model 8