Picked up a C-series Model 14 94XXX in .35 Rem, and since it is filthy internally, I decided to clean it. Followed the little bit of info available, without any problem except for the part about the cartridge stop that says it will “fall out.” Not on my rifle! I cannot get it out and therefore cannot slide the action out the back of the receiver housing.
Any advice or techniques would be much appreciated. Thanks.
Model 14 disassembly issue
Re: Model 14 disassembly issue
You can use a thick metallic needle to insert its tip into the hole in the cartridge stop, and then pull it up and out.