I am trying to fabricate a base pin for a 1875 Remington revolver. I am requesting any member that can help me to send some photographs and any measurements that you can. The base pin that I am working on has a slot and a square with an arm type spring /lock system. My email is paul@paradisefirearms.net.
If any one knows where to purchase such a reproduction of a original base pin that would help as well.
Thank you in advance for any help that you can offer.
1875 Remington Base Pin (Center Pin ) help
-
- Posts: 1
- Joined: Wed May 10, 2017 9:49 pm
Re: 1875 Remington Base Pin (Center Pin ) help
Hi Paul
Hope this is understandable.
Length: 7.55
Dia: 0.194 (don't mind the screw, it was just used for support)
Flat side: 2.145 long, 0.426 from the end, Dia 0.176 Lock arm length : 1.285 Width: 0.085 Cut out: 0.137 from end, length 02, debth 0.90
Best Reg
Eskil
Hope this is understandable.
Length: 7.55
Dia: 0.194 (don't mind the screw, it was just used for support)
Flat side: 2.145 long, 0.426 from the end, Dia 0.176 Lock arm length : 1.285 Width: 0.085 Cut out: 0.137 from end, length 02, debth 0.90
Best Reg
Eskil
Best regard
Eskil
Revolver kind of guy
Eskil
Revolver kind of guy