Remington Society

Joe : It's a receiver pin/plug which was part of the asssembly final steps used to hold the receiver/lower when the part was finished/milled for the finished slide rails and trigger installation. Usually left in the frame and still with the frame when it has been stripped like yours is. Find one an...

Hi all : Maybe the wrong place to post ... but .. if it is MOD or MODS ,,,,,, pls move to the correct place here at RSA I have a Rem 51 32 acp very good condition breechblock and extractor ( not installed ) that I will be listing on some of the auction sites in a day or so, if no one here wants it....

Here is another one.. need caliber and DOM.....

Just the frame with a little factory bluing left.

PA 48026

Tks

Deal : Unless you personally have done a COMPLETE disassembly of one of these before...my advice to you is... DON'T!!! If you do get your Rem 51 completely broken down into each part..and then can't remember how to put it ALL back together..or have a lost part due to the disassembly process.... A s...

Deal : This pistol barrel doesn't twist out like a Colt 25 32 or 380 caliber, " M " or " N " Models do... If I remember correctly.. a few of the early drawings ( before being favored to be made as you have ) and a very few of the manufactured prototype models had this feature, b...

Deal : Looks like step one... Remove the slide/barrel/breechblock ( if still there ) all in one piece, gives you viewing access to the frame,, safety looks like it's in the incorrect position. After removal of the slide/barrel/breechblock ( if still there ) all in one piece, move manual safety leve...

Welcome !!! Pics of your 51 ( caliber ?? ) should be taken and posted here, if you know how to do that. Might be useful to determine what your stage of problem is. For now.. yes original grips are expensive, try to find a broken set with the backing plate still attached and go with a repo set as re...