Remington Society

My newly-acquired 1548XXX gun has a bolt hold open issue that I think is caused by an out-of-true carrier that would not permit the carrier screws to fully seat after I removed them during disassembly. Upon reassembly the bolt would not hold open. On my next attempt I could not get both screws to pr...

Thank you again. That’s good info. I’ll see if I can do it.

Cheers, Lars

Thanks. The stop on my rifle does have a hole in it. If I remove it how tough is it to get it I back in?

My newly acquired Model 14 “C” 94XXX 1926, .35Rem., is filthy internally so I disassembled. All went OK until I got to the part where the Cartridge Stop is supposed to “fall out.” Didn’t happen and I can’t get it out. Reassembled rifle and it functions as it should. WTH? Any advice/techniques about ...

Picked up a C-series Model 14 94XXX in .35 Rem, and since it is filthy internally, I decided to clean it. Followed the little bit of info available, without any problem except for the part about the cartridge stop that says it will “fall out.” Not on my rifle! I cannot get it out and therefore canno...