Hello, I have a Remington model 31 and decided that I would give it a good cleaning, so I removed the trigger section and as I was removing the ejection rods the mechanical housing went to slide off my lap (barrel and stock are removed) and as I grabbed it I ended up pulling the slide all the way back, now the guide is down and in jammed position. any ideas on how I can fix this issue? I can't even put the gun back together at this point.
Thanks again for any help.
Marty
Model 31 Help
Re: Model 31 Help
Hopefully by now you have solved this problem. If not, reach in the ejection port and depress the ejector back against the receiver wall. Then push down on the shell lifter, while holding the ejector back.