Model 11 friction rings

Topics related to Post - 1898 Remington Shotguns
Post Reply
st33lcas3
Posts: 9
Joined: Mon May 25, 2009 4:06 pm

Model 11 friction rings

Post by st33lcas3 »

I have a Model 11 12 gauge (serial # 34xxxx). The friction rings aren't the same as the ones in all the instruction books. Instead of the bevel being on the outside of the steel friction ring, it's on the inside.

With the bevel on the outside, the bevel points towards the receiver for heavy loads. Is this the same when the bevel is on the inside of the ring or should the flat side of the steel ring sit against the spring?
remroc
Posts: 79
Joined: Wed Jan 27, 2010 4:44 pm

Re: Model 11 friction rings

Post by remroc »

As you have found out there are various versions of the friction ring. You should put the flat side toward the spring.
AuSable
Posts: 16
Joined: Fri Jan 08, 2010 3:24 pm

Re: Model 11 friction rings

Post by AuSable »

www.stevespages.com/page7b.htm

Try this link. You may have to copy and paste.
Scroll down to Remington Model 11 shotgun.
Post Reply