1875 Remington Base Pin (Center Pin ) help

Topics related to Pre - 1898 Remington Pistols
Post Reply
PaulParadis
Posts: 1
Joined: Wed May 10, 2017 9:49 pm

1875 Remington Base Pin (Center Pin ) help

Post by PaulParadis »

I am trying to fabricate a base pin for a 1875 Remington revolver. I am requesting any member that can help me to send some photographs and any measurements that you can. The base pin that I am working on has a slot and a square with an arm type spring /lock system. My email is paul@paradisefirearms.net.
If any one knows where to purchase such a reproduction of a original base pin that would help as well.
Thank you in advance for any help that you can offer.
Eskilgh
Posts: 39
Joined: Fri Jan 25, 2013 3:01 pm
Location: Norway

Re: 1875 Remington Base Pin (Center Pin ) help

Post by Eskilgh »

Hi Paul
Hope this is understandable.
Length: 7.55
Dia: 0.194
20171017_164147.jpg
20171017_164147.jpg (11.83 KiB) Viewed 1661 times
(don't mind the screw, it was just used for support)
Flat side: 2.145 long, 0.426 from the end, Dia 0.176
20171017_164251.jpg
20171017_164251.jpg (31.62 KiB) Viewed 1661 times
Lock arm length : 1.285 Width: 0.085
20171017_164312.jpg
20171017_164312.jpg (51.19 KiB) Viewed 1661 times
Cut out: 0.137 from end, length 02, debth 0.90

Best Reg
Eskil
Best regard
Eskil
Revolver kind of guy :D
Post Reply